As the machine is basically a copy of the Bowflex machine, books and manuals written for the Bowflex are useful for people with the Crossbow. It contains assembly and adjustment instructions, a parts list and exploded view, and very brief instructions on use of the machine.
Crossbow Manual. Bektronic was a lesser-known Chinese computer parts supplier fairly widely used back in the s and s. IBM actually sold motherboards for building clones for awhile. I sold quite a few computers built with these motherboards — they were cheap and fast. Here is the manual for it:. Here is the driver disk that came with it. It is WinImage format floppy image 1. It has a Winbond chip and is probably typical of many of these cards.
This is a manual for a generic Oak VGA card from It is amusing because it is so typical of generic parts of the era: no brand name or manufacturer but including a warranty card. They tried very hard to look legit. These were very common in very many generic versions.
The specs are xx 1MB. I think driver disks are pretty much interchangeable. Trident D driver I found a manual for a generic version of the Trident VGA. It took a while but I finally got a complete copy scanned. Here it is:. PCI manual. CNet sold a lot of stuff back in the day, and it was pretty good for cheap hardware. Anyhow, here is the manual:. This is a cheap Chinese digital timer for controlling power to a device. This is a copy of a catalog for Atlas Workshop Tools, a line of low-cost woodworking tools made in the US back when such things were made here.
An eBay listing for a copy of this catalog says it is from , but I suspect it may be from around If all you want to do is look at it, here you go:. I think they are all pretty similar in operation, so if yours is different this may still help. This is interesting because it describes how to install 3. Google will probably help. It has drivers for most of the motherboard chipsets of the era and would probably work for most motherboards based on those chipsets.
Here is a picture of the CD which lists chipsets and Bektronic motherboard models which are supported by this CD:. The Internet Archive is a great and growing resource for obsolete software of all kinds. Below this line is a list of chipsets and motherboards as printed on the CD, to help people find this post using search engines. A ew other thigs on the CD are at the bottom of the list. These use a special cutter head with integral blades that is no longer available, so my guess is that there are few people still using them.
This is the English part of the manual for this drill. Mine is about to be recycled as the battery is dead and I have much better, newer drills. J 5 Remote Operation The receiver can be set to operate in local or remote mode using the front panel keypad and LCD display. For the receiver to operate from a remote location, a connection must be made between the receiver and the master antenna controller or control device.
This section describes how to assemble the control cable and interpret the various control states. See Section 3, Operating Controls on page When the re … Only one converter may be fitted at a time they are not intended to beinterchangeable. Both are in fact capable of all mode reception. The fitting is recommended to be carried out in an experienced specialist receiverworkshop. All Rights Reserved. You may then decidewhether any item needs to be changed so that it is more appropriate for your specific installation.
Any of the settings shown may be changed as shownin the System Configuration section of the ow Trimble Navigation Limited. All rights reserved.
0コメント